Technology has evolved drastically in recent years. There are many different ways to securely keep the doors open, however, a simple hook and eye lock is still a favorite and convenient method for many out there.
Installing the hook and eye is not rocket science. With the right techniques and tools, you can do it in a jiffy. Let’s look at the steps you need to follow to successfully install a hook and eye on the door.
Check Out our service locksmith in texas for more Helps..
Here Is The 4 Step To Install Hook And Eye On Your Door
Before you start with the process, you need to mark the place where you want the hook and eye to go. There is no specific rule for choosing the place though. On French doors, the hooks are usually placed at the bottom.
However, on the front door, the hooks and eyes are generally placed right above the lock. This place is considered as the best position to put the hook and eye as it is the center of the door. Mark the position with a pencil so that you can place the hook accurately. Also, make sure that you mark the mounting hole on the opposite side of the door as well.
Now that you have selected the position, place the hook against the door. Drill pilot holes in the marked areas. Make sure that you drill the holes slightly smaller than the size of the mounting hooks. However, for hollow doors, drill the holes with the same size as the mounting hook. Then install there hook apparatus. The larger piece of the apparatus contains a hook that’s attached to an eye.
Place the anchor of the door behind the mounting hole of the hook. Now thread the anchor screw through the front side of the hook and into the anchor. After that, thread the screw halfway into the anchor.
The final step is to insert the anchors completely into the hole of the door and tap the screw to tightly secure it in place. You can use a hammer or any other heavy tool to tap it down. Also, tighten the screws with a screwdriver to ensure that the hook and eyes stay in place.
Materials Needed to Install Hook and Eye on Door?
You don’t need any fancy tools to install the hook and eye on the door. You need some simple materials such as pencil, measurement tape, screwdriver, drill and the hook and eye to get done with the job.
Also, make sure that you use the right drill bit designed for the door. Cutting bits are more suitable for the wood doors whereas, metal drill bits are the best choice for metal doors.
Also, we have a rookie tip for drilling as well. Tie a piece of paper on the drill to ensure that you’re not drilling beyond required. You may even end up drilling till the opposite of the door if you overboard with it.
Installing a hook and eye doesn’t require any hectic process. Still, it’s better safe than sorry. You can wear gloves to stay away from accidents. The drill bits will also spread throughout the place, so, make sure that you wear safety goggles to protect your eyes. Also, make sure that you thoroughly go through the instructions provided by the manufacturer.
Installing the hook and eye requires some easy and simple steps. Anyone can perform it with a little knowledge of DIYs. Remember, whenever you’re performing a DIY task, make sure you take necessary safety precautions to avoid any accident. Also, make sure to follow the instruction guideline if there is any provided by the manufacturer.